* Estimated shipping rate for US 48 states. Final rate calculated at checkout.
Tools & Shooting Accessories
|Home » |
Scope Mount Drill Jig
Scope Mount Drill Jig
Sun Optics USA P/N ST1878
Sun Optics USA Scope Mount Drill Jig of Pro Gun Smith Quality. The scope mount drill jig works on all Springfields, All Enfields, All year Mausers & all Japanesse make rifles. Sun Optics USA Scope Mount Drill Jig Aligns Holes with Bore Using a Precision Ground Arbor Inserted Into the Receiver in Place of the Bolt. No Measuring is Required. The Drill Jig Includes:
1ea. Base Block
1ea. Bore Align Arbor
2ea. v Bushings
1ea. #31 Drill Bushing
1ea. #31 Drill
1ea. 6X48 Tap
2ea. Jig Bars (marked S & M)
2ea. Allen Cap Screws
1ea. Allen Wrench
Sun Optics USA Limited Lifetime Warranty For Material And Workmanship.
Pro Gunsmith Quality
Aligns Holes with Bore Using a Precision Ground Arbor Inserted Into the Receiver in Place of the Bolt
No Measuring Required
Includes #31 Drill Bit and 6X48 Tap
Lifetime Warrany For Material And Workmanship
|Average Customer Rating:
|| based on 11 reviews|
Average Customer Review:
( 11 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
1 of 1 found the following review helpful:
great productMay 30, 2013
A just recibed the jig, start to drill and belgican fn and this product do a great job.
comes WITH ALL THE TOOLS YOU WOULD NEEED TO TAKE THE JOB DONE.
qvick delivery god qvalityFeb 21, 2014
did not fit Mauser m96 just tree of four drill possession fits good quality easy to work whit good good
Labor saver!Sep 01, 2013
By Jon R. Fory
Well designed and easy to use. Four stars because of the inability to adjust for two mounting holes in the Mauser rear receiver bridge. That said, I'd buy this product again. A great labor-saver!
Well made;fits 93 mauser.May 24, 2013
By Maxwell T. Sandford
Ships with a second plate for other actions. Ships with a drill guide but without a guide for the tap. I made a tap guide on the lathe--a simple turning job. This vendor was out of stock and phoned to tell me there would be a delay and to ask if I wanted to wait for the delivery. Very good communication with the vendor and while you can make a guide, buying this one is easier.
Jig is Great, Drill guides are notJan 24, 2013
By Jacks Dad
I purchased this to drill and tap a Springfield 1903a3 receiver. Lines up the holes great, but the Drill guides are to short and allows the drill bit to flex and break. Bought Wheeler drill guides which are full length and it works perfectly. Just used it on a mauser 98. Worker great on the Front holes, the rear holes a different story (leupold bases) the last hole cannot be drilled using the jig. I used the Base and a carbide drill to drill the last hole.
Overall I like the jig. Has a few problems, but what doesn't.
See all 11 customer reviews on Amazon.com